The Greatest Guide To h4831sc

The Greatest Guide To h4831sc

Blog Article

I picked up a 50ct. box of one hundred sixty Nosler Accubonds, but I am hesitant to burn up the powder and projectiles on workup when all I've is fifty bullets. But I really want to locate a bullet from the one hundred sixty class that my more mature rifle likes.

I've employed H4831 (and H4831SC), and I use it. There aren't numerous cartridges which i use it for as I seem to be constantly to gravitate to other powders. On the other hand, I am unable to state that it does not perform. It is just that some other powders work better for any provided cartridge. As an example, inside the 280, H4831 gave me great velocity and very fantastic groups with Nosler a hundred and forty AB. On the other hand, RL19 was marginally greater in accuracy, though the velocity was nearly identical.

It is really possible that no even further discussion is necessary, through which scenario we suggest starting off a different thread. If nonetheless you feel your response is required you may even now accomplish that.

Run your load up with the precise powder (sc or typical) and ton you're working with even though. Similar burn level doesn't mean it is going to behave "accurately" exactly the same. I've viewed over one hundred fps distinction between sc and mil-surp lots of H4831.

INgunner54 reported: It's been a little bit, but I did get some 4831 SC to test. Uncovered a node and shot some teams.

Given h4831 vs h4831sc that there would not seem like any "Formal" Load Data available for this Load, can a number of you offer a place to begin with this mix and points to think about when Functioning this Load up?

NBTs or Hornady VMax, but have a limited supply of Varget, as well as a whole lot additional out there H4831SC. I shoot fifty five gr. loads Virtually solely, due to the fact that is definitely just what the rifles shoot the ideal.

Anyhow, I desired to give some 7828SC a attempt to minimize some of the compression. What a miscalculation, I could not get this powder to shoot correctly or produce the velocities I get with standard 7828.

I could stack em in a single hole but I wasn’t satisfied with the velocity. After months, I acquired Fortunate and caught some H1000 on the net and of course paid out just a little excess. The quite next week at a gun clearly show a man had a complete case of H1000 for $40 for each 1lb. I forget simply how much, but While using the H1000 I’m now pushing a 160gr about 3200 and it’s a moderate load.

Additionally, it goes on to mention h4831 vs h4831sc that due to the fshorter grains, that load density is likely to be a bit greater.

This is an older thread, you might not receive a response, and will be reviving an aged thread. Please think about creating a new thread.

NBTs or Hornady VMax, but have a constrained source of Varget, as well as a large amount a lot more out there H4831SC. I shoot 55 gr. loads Practically completely, simply because that is definitely what the rifles shoot the most effective.

Southwest Idaho I attempted H4831sc in my three hundred WM but had far better pace and precision with H1000. I'd fairly utilize a slower burning powder with 215g pills.

The point that the H4831 is in fact a slower burning powder is h4831sc precisely why you might be viewing higher velocities received with that powder, instead of what you've viewed With all the IMR things.